It’s actually quite common and is in theory superior to side grain ones. Dulls the knife less this way. All the cutting and gluing does make it more expensive though. I’ve never used one, so I’ll have to make one for myself and see if the hype is true.

Tried it today, didn’t expect much, but I have to say I was pleasantly surprised at the speed and look and feel. I will give it a try for a while to see if I will switch from vscode permanently.

mexican russian joker

This looks the most promising. I’ll take a closer look. Does it provide a rtsp stream?

Any PC that has virtualization features can be used. Unless it’s very old, I’d say it’s supported. But it may not be enabled in the bios by default. It’s called VT-x for Intel and AMD-v for AMD, I think. But both are supported for at least 10 years on almost any PC.

It’s a hypervisor level virtual machine host and you can use it to install multiple os’s on the same machine with little overhead. I’ve been running haos like that for a few months now and I’m super satisfied.

Yes, for one device, I’d do wifi too. ZigBee does add complexity, but it also adds many possibilities. Esphome is a good solution, I use it also. In fact it seemlessly integrates with HA, so it doesn’t matter

One of the bigger reasons is ZigBee is capable of mesh network forming, which is useful if you want more devices to be smart. It’s also low power. And the devices are in their private network isolated from the internet, which is also a desirable quality. In summary, ZigBee is built for smart devices, whereas wifi not so much.

This is great! I’ve only recently discovered jq and was thrilled to have it after bashing my head in bash for a couple of days. I replaced the whole operation with a single line. This tutorial is just what I need. I like that it’s interactive and has neatly grouped examples! Bookmarking it, as I’ll need it very soon again.

This seems like the best option for my country. They are easily available and seem cheaper than Reolink. Do they have free API for all the smart functions as well? Like movement detection etc.

I have a newer ZigBee 3.0 dongle and run a few add-ons, but nothing big - z2m, nodered, mosquito is all I use. I will upgrade anyway, but I’m not in a hurry, it works fine, apart from an occasional delay in switching, which might be network related.

When you switched from pi3 to NUC , did you notice any performance improvements? I’m asking because I run my setup on a rpi3 and it mostly works ok, but the latency is sometimes high, so I’m wondering if upgrading the host will improve things.