Manufacturers say that installing a couple of 300-watt panels will give a saving of up to 30% on a typical household’s electricity bill. With an outlay of €400-800 and with no installation cost, the panels could pay for themselves within six years.

In Spain, where two thirds of the population live in apartments and installing panels on the roof requires the consent of a majority of the building’s residents, this DIY technology has obvious advantages.

With solar balconies, no such consent is required unless the facade is listed as of historic interest or there is a specific prohibition from the residents’ association or the local authority. Furthermore, as long as the installation does not exceed 800 watts it doesn’t require certification, which can cost from €100 to €400, depending on the area.


As with all solar power systems, balcony power only works in daylight and a battery storage system can add at least €1,000 to the installation cost.


Vernetta says the vertical surface area of cities is far greater than that of the roofs and that, in Spain, balcony panels benefit more than roof panels from the low winter sun.

Cities such as Helsinki are already experimenting with buildings with solar panel cladding.

  • sanzky@beehaw.org
    link
    fedilink
    arrow-up
    6
    ·
    5 days ago

    they have a “micro inverter” you literally just plug them into a socket in your house.

      • sanzky@beehaw.org
        link
        fedilink
        arrow-up
        1
        ·
        3 days ago

        why? they put around 600w max. there are plenty of appliances in a home that put a higher load than that.

        • lime!@feddit.nu
          link
          fedilink
          English
          arrow-up
          1
          ·
          3 days ago

          because they backfeed into the grid, and because that means you have live male plugs.

          • sanzky@beehaw.org
            link
            fedilink
            arrow-up
            1
            ·
            edit-2
            18 hours ago

            they are not live. before they feed the grid they need to synchronize to the grid’s phase

            -they detect AC from the grid

            -they sync the phase to it

            -start feeding