Hi all,

I’ve been having some trouble getting some decent lightbulbs. Which brand do you guys recommend? I’ve bought some Livarno (Lidl) ones, not full RGB, but when I choose a warmer color they become a little red/pink.

Edit: Thanks for all the suggestions! I’ll check out Ikea or Philips if I can find a good deal on them.

Edit 2, 25 days later: Bought the Tradfri 1055 lumen lightbulbs, setup was easy, and the Zigbee range of these lightbulbs is far better than the Livarno ones. Adding them to zigbe2mqtt was easy: enable permit join and reset the lightbulbs by flipping the switch 6 times.

  • roofuskit@kbin.social
    link
    fedilink
    arrow-up
    16
    ·
    1 year ago

    I have tried a lot of different ZigBee bulbs over the years so here is my two cents. All of these are referring to the white spectrum bulbs from these brands as that’s all I buy, no RGB.

    The BEST are probably Phillips Hue. I only use white spectrum bulbs not RGB so they are not $50 each, but they are still by far the most expensive.

    My favorite are the cheap white label ones I used to buy from Amazon and Home Depot under different brand names for $5 dollars and were clearly made by the same manufacturer. The ZigBee stick even saw them the same. But I can no longer find them. They have an amazing price to quality ratio.

    I really like the IKEA Tradfri bulbs but they are by far the most finicky bulbs I have when using a ZigBee stick instead of their native hub. They are fine 95% of the time, but sometimes they get annoying and won’t turn off or respond too slowly, or they just stop responding and need to be powered off completely to reset them.

    My least favorite is SengLED. They are cheap but do not act as repeaters so they will ruin your mesh network. I will never buy more of them.

    I would also avoid the OSRAM Lightify brand, I think it’s a Sylvania brand. Those have had the highest failure rate for me and it’s clearly because they run insanely hot. They will burn your hands if you don’t shut them off before changing them.

  • Nimmo@lem.nimmog.uk
    link
    fedilink
    English
    arrow-up
    6
    ·
    1 year ago

    I’ve been quite happy with my Tradfri Ikea bulks. Got some spread throughout the house. I did have one RGB bulk I got from AliExpress, but although it could do a whole range of colours it just didn’t have the brightness I was looking for. I haven’t tried the Phillips Hue ones though, so they might be better. I just happened to be in Ikea and spotted them, so went for it purely because of the fact I was needing some and walked past them. Had I walked past some Hue ones instead I’d probably have considered going for them instead.

  • TDCN@feddit.dk
    link
    fedilink
    English
    arrow-up
    3
    ·
    1 year ago

    Happy with my IKEA bulbs. It’s bang for the buck and you can be pretty sure they won’t set your house on fire since Ikea in general follows good electric design principles (from what I’ve been watching from bigclive on YouTube)

  • FeziSkull@lemmy.fmhy.ml
    link
    fedilink
    English
    arrow-up
    3
    ·
    edit-2
    1 year ago

    I personally use the Roku RGB ones that came out last year. It’s like $18 for three of them, total house done for under $100 with three bedrooms and all the common areas. They work well and sync to my home automation service, as well as having a geofence option to turn on/off when entering/exiting the general area of the home.

    I lived in a sketchy neighborhood prior and those bulbs saved our ass on a few occasions. People would come to the door, cameras would send an alert and all the lights would go on in an instant. This occured multiple times and it worked as a deterrent all of them.

    I also have some of the light strips synced together (there is a party mode with them, but unless you want to have a stroke I wouldn’t use it) and those create a good cohesive ambiance behind my desk and TV.

    I will ding them points for the party mode being hellish, and the app not having a dark mode, but they do sync quickly, reliably, and are user friendly to set up profiles and rules for.

    Hope that helps as I seem to be the only one not saying the Ikea ones (I have no experience with them so I cannot recommend something I’ve never tried)

    Edit: I wrote all this up and then decided to look into ZigBee as I realized thats the main concern of OP. I think this fulfills the functional requirements, but maybe not, so I’ll leave the comment just in case.

  • Hooolm@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    In my experience there’s nothing above Hue. Philips makes the best led bulbs out there.

    I’ve had decent results with ledvance as well in the sense that they’re robust and reliable but may take some tinkering to get the color/temp right.

  • Riven@sh.itjust.works
    link
    fedilink
    English
    arrow-up
    3
    arrow-down
    1
    ·
    1 year ago

    My IKEA bulbs are a few years old now so this might be outdated, but I found their coolest setting to be too warm. Phillips hue bulbs fixed that issue but their minimum brightness is too high. Pick your poison I guess.

    • objectivelyhidden@lemmy.fmhy.ml
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 year ago

      Glad I’m not the only one that thinks Philips bulbs are too bright. They’re my only smart bulbs though so I didn’t have anything to compare it to. My solution has been to change the colour to red when I dim them. They’re dimmer that way

  • 𝑔𝑎𝑙𝑎𝑥𝑖@lemm.ee
    link
    fedilink
    English
    arrow-up
    2
    ·
    edit-2
    1 year ago

    I have two different kinds of bulbs at my place. I have the IKEA bulbs everyone is mentioning, which have a nice range of hues to them, but actually their connectivity has left something to be desired (sometimes they’d need to be reset). On the other side, I have tunable white 2700-6500k Sengled bulbs that come in a 4-pack. I actually bought 12 of them when I started with HA and I’ve been incredibly happy with them. Highly recommend if you can find them for the price I did, which was $37/4-pack. The only downside to them is that they are a little squarish on top and a bit heavier since they have a glass top (but you don’t notice it when it’s installed). They’re a good brand to check out.

    Edit: I can never reply to kbin posters and I see roofus’ point but OP did want a cheaper option. I appreciate looking at the pros and cons but I will still say I’m happy with Sengled bulbs. Bulbs aren’t the only zigbee devices to act as mesh e.g. plugs. Their bulbs might not act as repeaters but they’re inexpensive, unlike Hue, and reliable, unlike IKEA. Do be sure to do a lil bit of your own research OP! You can always buy a couple and decide if you like them.

    • roofuskit@kbin.social
      link
      fedilink
      arrow-up
      4
      arrow-down
      1
      ·
      1 year ago

      DO NOT BUY SENGLED BULBS!

      SengLED has the misguided idea that people shut off the power to their smart bulbs regularly so they don’t sell bulbs that act as repeaters. Bulbs are the best possible repeater in a ZigBee network.

  • rambos@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    May I ask why smart bulbs and not smart switch in case you dont need rgb? What happens when you turn off wall switch? Smart bulbs stop working?

    • EyesEyesBaby@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      what happens when you turn off wall switch?

      They’ll go off. But when you turn the switch on again, the light goes on again. You can set that within Home Assistant.

      • rambos@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        First sentance sounds like normal switch and bulb, but maybe i missunderstood you

    • Grass@geddit.social
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Wall switch needs to have wiring that allows it to be always on which isn’t guaranteed if your house want built in a time where construction code demands it. Also just less beginner/non-electrician friendly in general especially in north America where the electrical boxes for switches are typically smaller.

      • rambos@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Oh thx, thats usefull. Im gonna do more research, but do you know what can I expect from appartment in new building in eu? Im about to move place in a month and im intersted in smart lights. Hopefully i can use smart switch like shelly 1. Its kinda confusing how to use smart bulbs with normal switch. I see myself spamming wall switch in a dark hehe. or maybe I just dont understand how it works yet

        • Grass@geddit.social
          link
          fedilink
          English
          arrow-up
          1
          ·
          edit-2
          1 year ago

          I’m not 100% on eu but for most wired in ZigBee devices you want 3 wires for it to be always on. 2 wire I think some people have made work anyways using a capacitor or something but that’s too sketchy for my liking. Sometimes the corresponding light recepticle has 3 wires instead, at least in one of my previous homes in Canada, and I was able to put the ZigBee switch in there instead. My current house is about half and half 2 and 3 wire and I’m just shit out of luck on those because the ceiling boxes are all 2.

          Sorry 2 or 3 plus ground which is bare here. Edit: also I think the capacitor was to prevent the 2 wire versions of the switch, which are different, from flickering

  • sylverstream@lemmy.nz
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I’ve got some from Aliexpress as we don’t have Ikea. They were a bit frustrating to set up, took a couple of re-pairs, but now they are working fine. They have all colors, but non-white is not very bright. I only use it with warm white.